Eaton Powerware 9390 Specifications download pdf (Page 19)

IAC Installation Plan and Unpacking

2-3

EATON Powerware

9390 IAC-B and IAC-T Installation and Operation Manual S 164201590 Rev C powerware.com

2.3 Inspecting and Unpacking the IAC

The cabinet is shipped bolted to a wooden pallet (see Figure 2-1) and protected with outer

protective packaging material.

CAUTION

쑺 The IAC is heavy (see Table A on page A-6). If unpacking instructions are not closely

followed, the cabinet may tip and cause serious injury.

쑺 Do not install a damaged cabinet. Report any damage to the carrier and contact your Eaton

service r epresentative immediately.

쑺 Do not tilt the IAC more than 10° from vertical or the cabinet may tip over.

1. Carefully inspect the outer packaging for evidence of damage during transit.

2. Use a forklift or pallet jack to move the packaged cabinet to the installation site,

or as close as possible, before unpacking. Insert the forklift or pallet jack’s forks

between the pallet supports on the bottom of the unit.

NOTE

Verify that the forklift or pallet jack is rated to handle the weight of the cabinet

(see Table A on page A-6 for cabinet weight).

Figure 2-1. Powerware 9390 IAC as Shipped on Pallet

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 145 146

No comments

Eaton Powerware 9390 Specifications Page 19