Eaton POWERWARE 9315 Installation Manual download pdf (Page 5)

1−1

EATON Powerware

9315 UPS (300–500 kVA) Installation Manual S 164201118 Rev H www.powerware.com

Chapter 1 Introduction

This manual describes how to install your Powerware

9315 uninterruptible power supply

(UPS) system. It contains instructions for installing the UPS and each optional component

and accessory. The information you will use depends on the system you purchased.

Each component of your UPS system is housed in a free-standing cabinet. The cabinets line

up and match in style and color, and have safety shields behind the doors for hazardous

voltage protection. Figure 1-1 shows a typical UPS system that includes at least one of each

component.

Input Cabinet

(Transformer

or Filter)

(optional)

Output

Transformer

(optional)

PDM Cabinet

(optional–

requires

480/208 transformer)

UPS

Cabinet

Battery

Cabinet

(optional)

Figure 1-1. Typical Powerware 9315 UPS System

These basic UPS system configurations are possible:

A The UPS and one or more battery cabinets

A The UPS, battery cabinet(s), and a Power Distribution Module (PDM)

A The UPS, battery cabinet(s), and an input cabinet (transformer or filter)

A The UPS, battery cabinet(s), PDM, and an input cabinet (transformer or filter)

A The UPS, battery cabinet(s), an input cabinet (transformer or filter) and an output

transformer cabinet

A The UPS, battery cabinet(s), PDM, an input cabinet (transformer or filter) and an output

transformer cabinet

You can enhance any of these system configurations by adding optional accessories such as

a Remote Monitor Panel (RMP), Relay Interface Module (RIM), Supervisory Contact Module

(SCM), or Remote Emergency Power−Off (EPO) control.

1 2 3 4 5 6 7 8 9 10 ... 97 98

No comments

Eaton POWERWARE 9315 Installation Manual Page 5