Eaton 9E10Ki Operations Instructions download pdf (Page 38)

UPS System Installation

4-2 Eaton 9E UPS (20–30 kVA, 208/220V) Installation and Operation Manual 164202124—Rev 5 www.eaton.com/powerquality

Figure 4-1. Removing the Front Shipping Bracket

5. Remove four bolts securing the rear shipping bracket to the cabinet and four bolts securing the bracket to

the pallet (see Figure 4-3). Remove the rear shipping bracket. If installing the cabinet permanently, retain

the shipping bracket and securing hardware for later use.

WARNING

Do not stand directly in front of the pallet while unloading the cabinet. If unloading instructions are

not closely followed, the cabinet may cause serious injury.

6. Slowly roll the cabinet toward the front of the pallet. Continue rolling the cabinet down the ramp until the

cabinet is clear of the ramp (see Figure 4-4).

7. Roll the cabinet to the final installation location.

8. If installing the cabinet permanently, retain the shipping brackets and hardware; otherwise, recycle the

pallet, ramp, and shipping brackets in a responsible manner.

9. Secure the UPS cabinet in position by lowering the leveling feet until the cabinet is not resting on the

casters and the cabinet is level.

Front Door

Front Shipping Bracket

Shipping Bracket

Bolts

Shipping Bracket

Bolts

Pallet

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 111 112

No comments

Eaton 9E10Ki Operations Instructions Page 38