Eaton RTC-50 Instruction Manual download pdf (Page 10)

Instruction Booklet IB 70-8698

Instruction Manual for the Eaton RTC-100

Automatic Transfer Switch Controller

EATON CORPORATION www.eaton.com

Effective December 2009

4.1.3 Reset Pushbutton

If, during normal operation, a transfer (from utility to generator

or from generator to utility) does NOT occur when it should, the

“CONNECTED” LED’s (WHITE or YELLOW depending on which

source should be connected) will flash (see Figure 4). Once the root

cause of the failure to transfer has been corrected, the “RESET”

pushbutton (see Figure 4) needs to be momentarily depressed

(about 1 second) to reset the board.

Figure 4. Reset Pushbutton and Connected LED’s.

“Connected“ LED’s

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

Eaton RTC-50 Instruction Manual Page 10